U-Boot 1.2.0 (Oct 11 2007 - 19:53:33) - PXA270@400 MHz - 1533M

*** Welcome to Gumstix ***

DRAM:  64 MB
Flash: 16 MB
Hit any key to stop autoboot:  0
Instruction Cache is ON
Copying kernel to 0xa2000000 from 0x00f00000 (length 0x00100000)...done
## Booting image at a2000000 ...
   Image Name:   uImage
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    992412 Bytes = 969.2 kB
   Load Address: a0008000
   Entry Point:  a0008000
OK

Starting kernel ...

Linux version 2.6.21gum (dhylands@dave) (gcc version 4.1.1) #4 Mon Oct 1 22:16:45 PDT 2007
CPU: XScale-PXA270 [69054117] revision 7 (ARMv5TE), cr=0000397f
Machine: The Gumstix Platform
Memory policy: ECC disabled, Data cache writeback
Run Mode clock: 208.00MHz (*16)
Turbo Mode clock: 416.00MHz (*2.0, active)
Memory clock: 104.00MHz (/2)
System bus clock: 104.00MHz
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists.  Total pages: 16256
Kernel command line: console=ttyS0,115200n8 root=1f01 rootfstype=jffs2 reboot=cold,hard
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62848KB available (1748K code, 192K data, 132K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
NET: Registered protocol family 2
Time: pxa_timer clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
JFFS2 version 2.2. (NAND) (SUMMARY)  (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler cfq registered (default)
Console: switching to colour frame buffer device 80x24
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
Probing Gumstix Flash ROM at physical address 0x00000000 (16-bit bankwidth)
Gumstix Flash ROM: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
Using static partitions on Gumstix Flash ROM
Creating 3 MTD partitions on "Gumstix Flash ROM":
0x00000000-0x00040000 : "Bootloader"
0x00040000-0x00f00000 : "RootFS"
0x00f00000-0x01000000 : "Kernel"
TCP cubic registered
XScale iWMMXt coprocessor detected.
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 132K
NET: Registered protocol family 1
mmcblk0: mmc0:d371 SU01G 992000KiB
 mmcblk0: p1
eth0: LAN9117 (rev 1) at 0xc4872000 IRQ 131
eth0: Ethernet addr: 2a:b8:6b:c4:ef:90
CPLD responded with: 00
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
pxa27x-ohci pxa27x-ohci: PXA27x OHCI
pxa27x-ohci pxa27x-ohci: new USB bus registered, assigned bus number 1
pxa27x-ohci pxa27x-ohci: irq 3, io mem 0x4c000000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
cfio: module license 'unspecified' taints kernel.
Initializing random number generator... done.
Starting Bluetooth subsystem: hcid.
Starting network...
udhcpc (v0.9.9-pre) started
Dec 31 16:00:15 udhcpc[343]: udhcpc (v0.9.9-pre) started
Nothing to flush.
eth0: link down
NET: Registered protocol family 17
Before register driver
Entering cf_attach()
pcmcia: request for exclusive IRQ could not be fulfilled.
pcmcia: the driver needs updating to supported shared IRQ lines.
BasePort1=0xc4880000, AssignedIRQ=128
After calling wlan_add_card function
After register driver
udhcpc (v0.9.9-pre) started
Dec 31 16:00:17 udhcpc[375]: udhcpc (v0.9.9-pre) started
Nothing to flush.
Starting Rendezvous:
NET: Registered protocol family 10
ADDRCONF(NETDEV_UP): eth0: link is not ready
Mobile IPv6
Starting dropbear sshd: OK
Starting httpd...
Starting system message bus: done



Welcome to the Gumstix Linux Distribution!

gumstix login: root